TatMapper shop-beta checklist
Use one sheet per shop and physical print path. Do not record client names or
retain identifiable client images in repository evidence.
Test identity
- Tester name or anonymous code:
- Date:
- TatMapper version / version code:
- Source commit:
- Device model:
- Android version:
- Folded/unfolded or screen size:
Placement and scale
- Scale reference: quarter / Placement Card / ruler / other:
- Nominal quarter, card, or ruler measurement:
- Physically measured reference:
- Reference kept flat in the placement plane: yes / no:
- Time from start to export:
- Confusing screens:
- Errors or recovery used:
Complete print path
- Regular printer manufacturer/model:
- Printing application and version:
- Driver/version:
- Actual Size selected: yes / no:
- Fit to Page disabled: yes / no:
- Paper size/media:
- Thermal copier manufacturer/model, if used:
- Heat/speed/density, if adjustable:
- Stencil-paper type:
- Single sheet or tiled:
- Tiled alignment/assembly result:
Final measurements
- Nominal horizontal ruler: 100.00 mm
- Measured horizontal ruler:
- Nominal vertical ruler: 100.00 mm
- Measured vertical ruler:
- Final paper-master result:
- Final stencil result:
- Artist would use TatMapper again: yes / no / unsure
- Why:
Release decision roll-up
| Workflow |
Status |
Required evidence |
| Ordinary paper printing |
NOT TESTED until recorded |
Final X/Y ruler measurements and setup |
| Regular printer → thermal copier |
NOT TESTED until recorded |
Paper-master diagnostic plus final-stencil X/Y |
| Direct stencil printer |
NOT TESTED until recorded |
Final-stencil X/Y and repeat print |
| Oversized tiled assembly |
NOT TESTED until recorded |
Every tile, overlap/alignment, final assembled rulers |
Owner report on 2026-07-25: TatMapper was attractive and easy to use, and the
emailed PDF printed at the expected physical size. Exact printer settings and
measured X/Y rulers were not recorded, so this remains OWNER REPORTED, not
scientifically verified physical calibration.